R-Matala, the perfect "drop in" media for Vortex filters and barrel filters. R-Matala has the same qualities as the sheets of Matala but formed into a coiled pre-cut cartridge. Simply select the diameter roll and the density you need for your round tank and drop it in. R-Matala coils are not designed to be un-rolled. They are pre-cut to fit your tank. Custom sizes can be special ordered.
SUPER HIGH DENSITY GRAY
The Gray Matala® will filter out a much smaller particle and yet still maintain good flow distribution. The Gray R-Matala should be used as the final stage in your filter flow. In larger systems all four types can be used in sequence to essentially remove all solids.
The Gray R-Matala should be used as a high efficiency biological filter media due to it's very high available surface area and free flow of water. Nitrifying bacteria will thrive within the Gray R-Matala environment.
R-Matala will naturally wedge in place without any need for support. However, you must measure the inside diameter of your tank and order the coil size which fits tight. If the coil fits too loose then the water will flow around the pads instead of through them. Four sequential densities can be perfectly employed to achieve maximum solids / bio-filtration. Each roll is 6 inches thick with a tremendous potential to trap dirt and yet is super easy to clean. Simply drain the waste out your bottom drain and gently pour pond water over the R-Matala.
Matala media works perfectly with upflow filter designs. The ideal upflow configuration would be the Black or Green R-Matala at the bottom of filter to capture the large particles. The next layer should be the Blue R-Matala to act as a biological filter and will filter out a medium size particle. The final layer will be the Gray R-Matala for high surface area biological filtration and fine particle removal. If you only have room for three layers of R-Matala, we suggest you use the Black on the bottom followed by the Blue and the Gray.
To clean an upflow filter with R-Matala you can pour pond water from the top down and flush out the waste down the bottom drain of the filter tank. If your filter tank does not have a bottom drain you may have to remove the layers of Matala to clean them. Routine "top down flushing" with pond water will prevent sludgy build up on the bottom layer. Occasionally you will need to remove the layers to inspect the bottom coil for clogging.
|R27GRY||Grey R-Matala 27-inch||Was $119.00$101.00||90||Ships 4 Free|